This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
pto output shaft
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 131
- Joined: Wed Nov 26, 2003 9:47 pm
- Location: Surry,VA
pto output shaft
replacing the pto out put shaft bearing and seal i used napa cross referance parts the seal is much thinner,i was wondering if this is new and inproved or just cheaper does anyone have any idea thanks alot as always and have a great weekend
- Bigdog
- Team Cub Mentor
- Posts: 24144
- Joined: Sun Feb 02, 2003 12:50 pm
- Zip Code: 43113
- Circle of Safety: Y
- Location: OH, Circleville
- Contact:
Some of the guys double up on those thinner seals. At the least, you have a choice where you seat the seal so you can make sure it rides on an un-worn area of the shaft.
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
- John *.?-!.* cub owner
- Cub Pro
- Posts: 23701
- Joined: Sun Feb 02, 2003 2:09 pm
- Zip Code: 63664
- Tractors Owned: 47, 48, 49 cub plus Wagner loader & other attachments. 41 Farmall H.
- Location: Mo, Potosi
Many of the new seals are thinner than the old ones, which is good if you have a wear groove, it allows you to seat it so it runs in a new place as BD stated. Unless the inner seal is leaking to start with, I question whether anything is gained by installing 2 seals, since the outer one will wear out very quickly from running dry. The continous splash of oil lubricates the seal lip the same as it does the gears and bearings.
If you are not part of the solution,
you are part of the problem!!!
you are part of the problem!!!
-
- Team Cub
- Posts: 17278
- Joined: Sun Feb 02, 2003 2:59 pm
- Zip Code: 55319
- Circle of Safety: Y
- Location: MN
Who is online
Users browsing this forum: CaperKen, farmallcubkid, taiterhead, tucker86 and 56 guests