Ok Guys,
Thanks to Jim for sending the pictures from TM-parts.
Here is the low-down.
Turn the crank [as if you were trying to start the engine] in a clockwise
direction to where the double punch marks are visible in the
magnito/distributor mounting hole, then continue to turn the crank and count off fifteen (15) valleys [the area between the gear teeth] past the double punch marks that is where the single punch mark will be on the back side of the idler gear. You can also check in the opposite direction, if you like, it would be twenty one (21) valleys in that direction.
Then you can mark the teeth on both sides of that valley.
I checked this with another engine I have torn down.
I hope this helps someone else.
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Timing Gear Alignment
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 251
- Joined: Sun Feb 09, 2003 10:05 pm
- Location: MS, Oxford
Who is online
Users browsing this forum: No registered users and 19 guests