Page 1 of 1
Magneto to Distributor Question
Posted: Sat Aug 28, 2004 5:41 pm
by WJ
I am want to swap out from a mag to distributor on my 1950 cub. I have a distributor from a farmall C. Is that a direct swap or do I need to change out some parts??
Thanks for any help.
Posted: Sat Aug 28, 2004 9:09 pm
by Wireharness
They look alike however they are differint.
Posted: Sat Aug 28, 2004 9:25 pm
by Rudi
Posted: Sat Aug 28, 2004 9:39 pm
by Jim Becker
The timing advance is different. IH made some timing changes on some engines, so these numbers may not be exactly right for all years. But my reference shows the Cub max of 16 degrees at high idle (1800). The most common version of the C is 30 degrees at high idle (1650).
I think the code letter(s) for each distributor are stamped into it somewhere. You might inspect your distributor to see if it is stamped. The Cub distributor is D, the C distributor I described above is J.
Posted: Sat Aug 28, 2004 11:11 pm
by WJ
Posted: Sat Aug 28, 2004 11:17 pm
by Donny M
Posted: Sat Aug 28, 2004 11:21 pm
by WJ
Posted: Sat Aug 28, 2004 11:27 pm
by Donny M
Posted: Sun Aug 29, 2004 7:38 am
by Bruce Sanford
Well I just did the same thing,from mag to distributor. I also went back to a six volt system. I was never keen on mags.Don!t tell the correct police
Posted: Sun Aug 29, 2004 9:47 am
by WJ
Bruce Sanford wrote:Well I just did the same thing,from mag to distributor. I also went back to a six volt system. I was never keen on mags.Don!t tell the correct police
Was your distributor from one of the letter series tractors or was it from another cub
Posted: Sun Aug 29, 2004 6:54 pm
by Bruce Sanford
10
It was from another cub and worked quite well .After we did an overhaul on it.It was worn out to.My luck