This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Governor Overhaul Procedure
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
Bronco
- 10+ Years
- Posts: 8
- Joined: Thu May 27, 2004 10:09 am
- Location: Ohio, Ostrander
Governor Overhaul Procedure
[b]Can someone help me out with a step by step governor disassembly and rebuild procedure? Vehicle in question is a 1971 Yeller &White Cub. Thanks in advance, Bronco.
-
RedNed
- 10+ Years
- Posts: 481
- Joined: Mon Feb 03, 2003 6:32 pm
- Location: Long Island,New York
Bronco,The manual Gss-1411 has all the info you need.Take the gov. off ,remember to see where you marks are on the gear.Put the unit in a aluminum or Brass vise holding the gear, soak the bottom of with kroil or liquid wrench or wd-40.Heat the housing,lightly tap the outer edges of housing.it should break free there should be a alighment pin on the bottom . Everything will slide out.weights and so on.there a garlock seal thats available from case/IH,clean everything up and inspect.....installation is reverse of disassembly..There I sound like a Chilton car manual 
..Bronco See if you can get that GSS manual its pretty user friendly....
..Bronco See if you can get that GSS manual its pretty user friendly....Who is online
Users browsing this forum: No registered users and 59 guests
