Governor Overhaul Procedure

Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.

Governor Overhaul Procedure

Postby Bronco » Fri Aug 06, 2004 12:32 pm

[b]Can someone help me out with a step by step governor disassembly and rebuild procedure? Vehicle in question is a 1971 Yeller &White Cub. Thanks in advance, Bronco. :?
Bronco
10+ Years
10+ Years
 
Posts: 8
Joined: Thu May 27, 2004 10:09 am
Location: Ohio, Ostrander

Postby RedNed » Fri Aug 06, 2004 10:03 pm

Bronco,The manual Gss-1411 has all the info you need.Take the gov. off ,remember to see where you marks are on the gear.Put the unit in a aluminum or Brass vise holding the gear, soak the bottom of with kroil or liquid wrench or wd-40.Heat the housing,lightly tap the outer edges of housing.it should break free there should be a alighment pin on the bottom . Everything will slide out.weights and so on.there a garlock seal thats available from case/IH,clean everything up and inspect.....installation is reverse of disassembly..There I sound like a Chilton car manual :lol: ..Bronco See if you can get that GSS manual its pretty user friendly....
User avatar
RedNed
10+ Years
10+ Years
 
Posts: 481
Joined: Mon Feb 03, 2003 6:32 pm
Location: Long Island,New York


Return to Farmall Cub

Who is online

Users browsing this forum: No registered users and 2 guests