'48 Cub Project: Needing Hand crank dimensions
Posted: Thu Jul 29, 2004 2:27 pm
Hi:
I would like to build a short stub fitting for the front crank pulley out of round stock, fitted with the appropriate cross pin, with a large nut welded on the outboard end. I want to use it to turn the engine over as I'm working on it.
Can anyone tell me the diameter of the crank stock, and the size of the cross pin? Also, how much sticks out past the far side of the pin?
I'll probably buy a proper hand crank some day, but for now I just need to build spud driver.
I would like to build a short stub fitting for the front crank pulley out of round stock, fitted with the appropriate cross pin, with a large nut welded on the outboard end. I want to use it to turn the engine over as I'm working on it.
Can anyone tell me the diameter of the crank stock, and the size of the cross pin? Also, how much sticks out past the far side of the pin?
I'll probably buy a proper hand crank some day, but for now I just need to build spud driver.