Page 1 of 2

New member, first question

Posted: Tue Jul 27, 2004 12:54 pm
by Bob Roraback
Hello to everyone, I have purchased my first Cub tractor,I was told that it is a 1952. I thought that I would start by changing the oil and filter and also changing the fuel filter as it is having a problem where I will be going along fine and the engine cuts out and dies suddenly and wont restart until I wait a minute or so. My questions are as follows,
1. What weight and type of oil should I use.
2. Should I use a lead substitute in the gas?
3. What octane gas should I use.
4. Where can I get a new fuel filter and oil filter.
Does anyone have any suggestions on what else I should check or use?

Thank you all for the help that you provide,
Bob Roraback

Posted: Tue Jul 27, 2004 1:34 pm
by Bigdog
Bob, Welcome to the board! May I suggest that you read the posting at the attached link for many answers. The questions you have are common for most new cub owners. I will attempt to answer some of them for you and the answers to some of the others are strictly matters of choice.

The choice of oils is diverse. Some prefer detergent oil, some don't. Some prefer single viscosity, others don't. Generally, whatever the previous owner used is a good place to start. Essentially, a multi-grade detergent oil is a good choice. 10W-30 of your favorite brand. Then watch the dipstick to see how the oil looks after a short while. If the engine is going to need a rebuild, you can start clean with whatever you choose and it will be OK.
Unleaded regular gas should be fine. That's what most of us use. If it makes you feel better, use a lead substitute, but it isn't necessary.

Originally, the cub had no fuel filter. Just a sediment bowl at the tank outlet. If there is a filter in your gas line, it has been added by a previous owner. If you want to keep a filter in the system, choose a high flow filter designed for gravity fed fuel systems.

Oil filters can be purchased from a Case IH dealer or from a good auto supply store such as NAPA. There are cross reference numbers in the cub FAQs.

Your problem sounds like a fuel starvation problem. There is a screen at the fuel inlet to the carb. Also an air vent in the cap on the tank can become plugged causing a vacuum and thus fuel starvation.

Read the FAQ's and check the links and anything you can't find, someone will be able to answer for you.

Here's the link for new members:

http://www.farmallcub.com/phpBB2/viewtopic.php?t=1459

Thanks

Posted: Tue Jul 27, 2004 2:05 pm
by Bob Roraback
Thanks Big Dog, I will use that link and start there. I agree that it is a fuel starvation problem . I will let you know what I find. Thanks again for answering, Bob

Posted: Tue Jul 27, 2004 4:38 pm
by Rudi
Bob:

Welcome to the Cub Forum and to the Cub Family :D

BigDog gave you some good advice. Now, I will drop in me dos centavos worth.

Do yourself a very big favour. Go to Binder Books and order these three manuals.

Cub Owners Manual (good for regular and lo-boy all years)
TC-37F Parts Manual
GSS-1411 Service Manual

The good folks on this forum gave me this advice 2 years ago when I was just a newbie Cub nut and had aquired the first of my present 3 Cubs. They have proved invaluable. In fact they are absolutely essential as most of the questions you have are answered in those three manuals. The parts manual is especially useful for the cut-away and the exploded diagrams. Also, it is basically imperative that when ordering parts from your CaseIH counter man that you have the part number. It sure simplifies everything and the right part usually gets ordered.

In the meantime, and I know BD just overlooked this :roll: right BD :oops: :?: , if you click on the link below in my signature line, it will take you to the Cub Manual Server. Spend some time there looking things over. Most of the info you need is there.

Speaking of which, if you click this : Lurker Carl's Carb Fixes, most of what you need to know about your fuel problem is discussed there including which carb kits to buy and which to avoid like the plague :lol: .

As for oil, oil filter, hy-tran for your touch control if equipped and for most parts - your local CaseIH Dealer or Case Parts On-Line, will be your best source for good quality IH parts. If you do not have a local dealer, then Ken over at Carter and Grunewald can supply and ship your required parts etc., to you. You can also get parts at TSC, NAPA and other auto parts stores and sometimes it is cheaper, but you may find out that cheaper is not always better. I know I did :oops:

As for gas - regular unleaded is perfect and no lead additives are required nor recommended. The only thing you might want to do is to put some Marvel Mystery Oil in your gas tank occassionally according to the directions on the bottle. I am beginning to like that stuff :!: :idea:

Again, welcome to the Forum and to the Family. Betcha can't stop at one :!:

Posted: Tue Jul 27, 2004 4:58 pm
by Bigdog
Rudi, I didn't forget, I knew there was a link to your site in the posting to new members. I was just too lazy to cut and paste the address. Sorry my friend, your site is invaluable to everyone new and old alike. I wouldn't leave it out.

Thanks Rudi

Posted: Tue Jul 27, 2004 6:05 pm
by Bob Roraback
Thank your for the info Rudi! And I bet you are right about stopping at one. Bob

Posted: Tue Jul 27, 2004 6:59 pm
by Rudi
Hey BD:

Sorry buddy, but today you lucked out. Haven't yanked a chain today, so you got picked :lol:

Helpfull hints

Posted: Wed Jul 28, 2004 6:46 am
by Buggyscott
Bigdog is right on, go to Binderbooks and get the manuals. Got these even before I brought home 'My Missey' and they have been a life saver several times over. It is surprising how a major crisis turns into just a moments pause when you can look in the book and get a answer real quick without having to jack it up and start unbolting to see inside. Also just reading the post on this board has given me so much information that one of my wisdom teeth exploded the other day when it could not hold it all. Thanks guys for sharing what you have learned with this newbee.

Posted: Wed Jul 28, 2004 11:35 am
by Carm
Rudi, what turned you on to Marvel? I use it too. I was told about it bu an old aircraft mechanic, said he used it in all of his planes and other vehicles. I have been using it in all of the gas and diesel equipment, The C seems to run better now than it did. It could be from usage or the oil. Just curious.

Posted: Wed Jul 28, 2004 11:59 am
by Donny M
Bigdog wrote:
Rudi, I didn't forget, I knew there was a link to your site in the posting to new members. I was just too lazy to cut and paste the address. Sorry my friend, your site is invaluable to everyone new and old alike. I wouldn't leave it out.


Hey Bigdog, we know Rudi just turned 50 and sometimes has problems with his memory...so when's your birthday :?: :lol: :lol: :lol: :lol:

Posted: Wed Jul 28, 2004 12:18 pm
by Bigdog
Heh! Heh! Heh! Thats a carefully guarded secret!

Posted: Wed Jul 28, 2004 12:18 pm
by Rudi
Carm:

Everybody on the board almost has been singing the praises of MMO :lol: unfortunately, I cannot seem to find it here in Canada :cry: :? . Soooo when CubFest Northeast was almost upon us, CB graciously sent up some of the MMO for door prizes and for me to try.

I LIKE IT! A lot :D

Now, to try and figure out how to get more........

Posted: Wed Jul 28, 2004 12:24 pm
by Donny M
Bigdog,

When some says "Heh! Heh! Heh! Thats a carefully guarded secret!"

That really is telling :wink: It most likely means you forgot. :lol: :lol: :lol:

Posted: Wed Jul 28, 2004 12:26 pm
by Bigdog
I'll give you a hint. It's 3 days before my wedding anniversary.

Posted: Wed Jul 28, 2004 12:27 pm
by John *.?-!.* cub owner
Bigdog wrote:Heh! Heh! Heh! Thats a carefully guarded secret!
He's older than dirt. :lol: