Page 1 of 1
Starter spins, but won't engage
Posted: Sun Jun 06, 2004 8:09 am
by Holes49
My 49 Cub has been converted to 12 V. The starter spins, but won't engage. does this mean rebuild time ?
Is anything going to fly away when I take this off ?
Posted: Sun Jun 06, 2004 10:38 am
by johnbron
Nothing will fly away when you take the starter off. If you are lucky the cause might be just a dirty bendix action. Make sure the gear on the starter slides easily on the shaft. Also clean the shaft & gear good and leave it dry, Dont put any kind of lubricant on it. I clean mine with carb-cleaner.
Posted: Sun Jun 06, 2004 4:45 pm
by Holes49
Thanks johnbron that got me out of a pinch and got the grass cut. Apparantly my starter drive iwas broken and had jammed the gear fropm going forward. It this starter drive something a rebuilder would be able to get or by any chance can I service it myself.
John
Posted: Sun Jun 06, 2004 4:53 pm
by John *.?-!.* cub owner
Any rebuilder, and most "real" auto parts stores can get them or may even have them in stock. There is a right and left hand model, so be sure you get the correct one. I think the one for the cub is the left hand one, but I'm not sure. The difference is the spiral in the shaft.
Posted: Sun Jun 06, 2004 7:05 pm
by Holes49
Thanks
I assume right-side means right-side when I'm sitting on the seat. What are they like to change, I assume I pull the back (front of tractor) off the starter and go from there.
Posted: Sun Jun 06, 2004 7:34 pm
by Rudi
John:
It is well described in the GSS-1411. Seems like a simple job. Gordon did it on Saturday and said it only took a couple of minutes.
Posted: Sun Jun 06, 2004 8:36 pm
by John *.?-!.* cub owner
Holes49 wrote:Thanks
I assume right-side means right-side when I'm sitting on the seat. What are they like to change, I assume I pull the back (front of tractor) off the starter and go from there.
Right or left refers to which way the starter shaft spins when you try to start the tractor. Different model/brands of tractors used the same drive, but some of their starters spun the opposite direction. If you get one that is designed for the wrong direction it won't run the gear out to engage the flywheel.
Posted: Mon Jun 07, 2004 1:09 am
by Cdn Country Bumkin
John
That tractor is changed over to 12 V, but the starter is still 6 V,not that it makes any difference to your problem, just for your knowledge. Thats why it spins over so fast, and you should never spin it for long periods of time. Have you done anything to the Cub or is it still the same as when you bought it.
Archie
Posted: Tue Jun 08, 2004 3:05 pm
by Matt Kirsch
If it's anything like Dad's old M on 12V, it won't start unless you stop cranking
Posted: Tue Jun 08, 2004 8:30 pm
by Jim Becker
Matt Kirsch wrote:If it's anything like Dad's old M on 12V, it won't start unless you stop cranking
My '49 Cub was converted before I got it. It starts better now that I have converted it back to 6 volts. Of course, I had to fix the starter to get it to crank on 6 volts. It was either destroyed by the 12 volts or maybe that was what it needed before it was converted, probably some of both.
If it cranks too fast, the magneto impulse doesn't work right.