Rockshaft travel

Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.

Rockshaft travel

Postby Findoggy » Wed Jun 02, 2004 7:37 am

I'm just learning about cubs and mechanical topics, so please excuse my ignorance in asking this question. Is there any way to adjust the forward/backward travel in the rockshaft? I know you can place the stops where you want them, what I mean is the actual travel of the rockshaft. I want to gain more backward travel and lose some forward travel if at all possible. Thanks for the help gentleman.
Findoggy
User avatar
Findoggy
10+ Years
10+ Years
 
Posts: 310
Joined: Sun Nov 30, 2003 4:49 pm
Location: Lehighton, PA

Postby Jim Becker » Wed Jun 02, 2004 11:03 pm

Only to the extent the control lever stops change it.

Why do you want to do it?
User avatar
Jim Becker
Team Cub
Team Cub
 
Posts: 11920
Joined: Sun Feb 02, 2003 3:14 pm
Location: MN
Zip Code: 75048
Circle of Safety Award
Circle of Safety: Y

Postby Findoggy » Thu Jun 03, 2004 6:13 pm

Jim, you may recall I posted back in the fall/winter because my snow blade would only raise about 5 inches off the ground with the blade set on the last of the 5 adjustment holes. I tried tightening everything and using washers to take play out of the unit as suggested by you. I have also since that time filled the hydraulic unit to its proper level and bled the system of air. I was just wondering if there wasn't something I was overlooking to help get more clearance. I thought it would be better to deal with it while I had some nice weather. Thanks for your assistance.
User avatar
Findoggy
10+ Years
10+ Years
 
Posts: 310
Joined: Sun Nov 30, 2003 4:49 pm
Location: Lehighton, PA

Postby Jim Becker » Fri Jun 04, 2004 11:23 am

I remember the problem but not the specifics of what all was said. The only other suggestion I have (may have been made previously) is this. When you get ready to mount the blade next time, go to the TM Tractors site and look closely at the pictures of the mounted blades in the implement pictures. You can use them to make sure you don't have anything misassembled and no mixed parts from different versions of the blade.
User avatar
Jim Becker
Team Cub
Team Cub
 
Posts: 11920
Joined: Sun Feb 02, 2003 3:14 pm
Location: MN
Zip Code: 75048
Circle of Safety Award
Circle of Safety: Y

Postby Findoggy » Fri Jun 04, 2004 12:04 pm

Thanks for your help, it is always much appreciated
User avatar
Findoggy
10+ Years
10+ Years
 
Posts: 310
Joined: Sun Nov 30, 2003 4:49 pm
Location: Lehighton, PA


Return to Farmall Cub

Who is online

Users browsing this forum: Bill E Bob, Billy Fussell, Buzzard Wing, ericofmaine and 5 guests