Page 1 of 1
Having trouble installing fan pulley
Posted: Sat May 08, 2004 1:23 pm
by Steve Ruddy
I tried a threaded rod with some washers and a nut and got it on about half way and the thrads started stripping. Any tips? Do I need to have a threaded rod made out of harder material?
Posted: Sat May 08, 2004 2:14 pm
by Steve Ruddy
I guess I'll try heating it up like Donny said in this thread and use the same zinc threaded rod.
http://farmallcub.com/phpBB2/viewtopic.php?t=3240&highlight=fan+pulley
Posted: Sat May 08, 2004 3:06 pm
by Steve Ruddy
Success! I heated it up to 220 like Donny said and I also put wd40 on the shaft and threaded rod threads as well as using a stonger nut and washer.
Posted: Sat May 08, 2004 3:16 pm
by Bigdog
Steve, I was trying to reply to you and either my computer or the forum was hanging up. Yes, heat is the answer as you now know!
Posted: Sat May 08, 2004 10:01 pm
by Steve Ruddy
Thanks Big Dog
Posted: Mon May 10, 2004 2:58 pm
by Donny M
Posted: Mon May 10, 2004 5:29 pm
by Ron L
Steve. That's what we like. A question..... an answer..... then the successful application ! Good job..............
Posted: Mon May 10, 2004 10:07 pm
by Steve Ruddy
Where's my thanks?
This is a thankless job
Ha Ha Thanks Donny! I obviously was to anxious to wait for an answer. Luckily I found your thread! I also used what I had to push in the pulley. It was the slotted bar that was part of the puller I bought from Grainger to use with the bearing seperator to take the pulley off.
Posted: Mon May 10, 2004 10:20 pm
by Donny M
Steve,
Glad you got the pulley back on without using a trailer hitch.
It may have been a challenge to get it on but I know it wasn't as bad as taking it off. We're all looking forward to seeing your Cub running again