[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4493: ob_start(): output handler 'ob_gzhandler' conflicts with 'zlib output compression'
Farmall Cub • View topic - Having trouble installing fan pulley

Having trouble installing fan pulley

Sat May 08, 2004 1:23 pm

I tried a threaded rod with some washers and a nut and got it on about half way and the thrads started stripping. Any tips? Do I need to have a threaded rod made out of harder material?

Sat May 08, 2004 2:14 pm

I guess I'll try heating it up like Donny said in this thread and use the same zinc threaded rod.

http://farmallcub.com/phpBB2/viewtopic.php?t=3240&highlight=fan+pulley

Sat May 08, 2004 3:06 pm

Success! I heated it up to 220 like Donny said and I also put wd40 on the shaft and threaded rod threads as well as using a stonger nut and washer.

Sat May 08, 2004 3:16 pm

Steve, I was trying to reply to you and either my computer or the forum was hanging up. Yes, heat is the answer as you now know!

Sat May 08, 2004 10:01 pm

Thanks Big Dog :D

Mon May 10, 2004 2:58 pm

Hey Steve,

Where's my thanks? :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:

This is a thankless job :( :( :( :( :( :lol: :lol: :lol: :lol: :lol: :lol: :lol:

Mon May 10, 2004 5:29 pm

Steve. That's what we like. A question..... an answer..... then the successful application ! Good job..............

Mon May 10, 2004 10:07 pm

Where's my thanks?

This is a thankless job


Ha Ha Thanks Donny! I obviously was to anxious to wait for an answer. Luckily I found your thread! I also used what I had to push in the pulley. It was the slotted bar that was part of the puller I bought from Grainger to use with the bearing seperator to take the pulley off.

Mon May 10, 2004 10:20 pm

Steve,

Glad you got the pulley back on without using a trailer hitch. :lol: :lol: :lol: It may have been a challenge to get it on but I know it wasn't as bad as taking it off. We're all looking forward to seeing your Cub running again :!: