Page 1 of 1

belt pulley seal

Posted: Fri Feb 20, 2004 5:51 pm
by artc
i'm cleaning up a belt pully for Pete and got stuck on the input shaft seal. the seal says 19857D (CR), and TC-37 says it's replaced by 63 431 C1. neither number shows up in NAPA's cross.

the output seal was no problem.

:idea: ask the board :!: go to sleep.... wake up with the answer :lol:

thanks for the help

Posted: Fri Feb 20, 2004 6:05 pm
by John *.?-!.* cub owner
try a national 450048

Posted: Sat Feb 21, 2004 8:56 am
by artc
thanks, John. :!:

Posted: Sat Feb 21, 2004 10:38 am
by Brent
ARTC,

I just replaced both awhile back. The seal on the belt pulley shaft is a National #471765 and the one for the in-put shaft is a National #450048.
Hope that helps.