Elmers blade

Fri Dec 26, 2003 8:07 pm

Jim, I don't know how to get this on the forum, but I think you do. This came with the tractor when I got it, but I don't think it belongs. Do you know what it's for? Elmer


Image

Fri Dec 26, 2003 8:09 pm

Home made with 3 blades off some scrape on 2 plow beams with rear cultivator spring rods to lift it. I don't see how he hitched it up.

Blade

Fri Dec 26, 2003 10:17 pm

Jim, I think you nailed it. If you look closely, it appears as if the blade is actually made up of three cutting edges off a larger snow plow.

S.H.A.F.T.

Sat Dec 27, 2003 12:34 am

Probably bolted plow beams to wheel housings. For another use for plow beams , check harrow on my site. Dan

Elmers Blade

Sat Dec 27, 2003 11:16 am

Jim, I belive your'e right about the blade. I've had it for years but I never got around to really looking at it or trying to hook it up . When it warms up a little i'll try that. In the mean time i'll measure the plowshare width & see if I can figure where it would hook on the tractor. I also have 2 discs & other stuff i'll send pictures of.
Elmer.

Jim thanks,