Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Mon Jan 15, 2007 10:30 pm
It has now come to the part in my restoration to replace all the front seals on the engine. But I am not sure how to remove and replace the Governor without messing timing up. I have seen it on here before but cannot find the thread. Can some one break it down step by step. On how to take it off and put back without messing timing up.
Tue Jan 16, 2007 10:03 am
If I was you I would remove the governor and retime the Cub. If your governor is needed a tune-up the engine timing will probably need one also. It only takes a few minutes to retime. We had a nice CubFest how to on governor repair and clean-up Saturday. You have raised a good question though.
Tue Jan 16, 2007 11:04 am
I prefer to line the engine up on timing mark for no1 cylinder with both valves closed then remove the gov
Tue Jan 16, 2007 1:01 pm
As Ron said - set the engine with #1 cylinder at TDC on compression and be sure it does not move while the governor is off. It will then be easy to replace the governor properly timed to the engine.
Tue Jan 16, 2007 1:12 pm
If you have not removed the governor just yet, remove the drive seal first. Then with number 1 cylinder at TDC you can use nail polish to mark the timing gears.
There are punch marks on the gears but hard to see (tired eyes
). On reassembly install the governor per the marks and put the new seal in after the governor is installed.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.