This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
pitman question
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Drfting1
- 5+ Years
- Posts: 543
- Joined: Wed Nov 02, 2016 7:25 pm
- Zip Code: 24151
- Tractors Owned: 53 Cub
59 cub - Circle of Safety: Y
- Location: Rocky Mount VA
pitman question
Have a question, I cut the pitman arm to lenght, going to drill holes. What is supposed to be the diameter and depth where spring goes in? I tried searching, seen there was a pattern but link is not working... Thanks
Bill Longeill
-
- Team Cub
- Posts: 11827
- Joined: Tue May 25, 2004 8:02 pm
- Zip Code: 80501
- Tractors Owned: Cubs, MH Pony, Shaw, Allis G, 1934 Silver King, JD LA and LI, Gibson D, David Bradley Tri-Trac
- Circle of Safety: Y
- Location: CO, Longmont
Re: pitman question
On the one I measured, the hole depth is 1.55" and diameter of the hole was 0.67". An 11/16 " drill bit is 0.69. You'd just need enough clearance for the spring to compress, so you may want to measure your spring and drill accordingly.
"We don't need to think more,
we need to think differently."
-Albert Einstein
we need to think differently."
-Albert Einstein